ASTM D4066 PDF

Buy ASTM D CLASSIFICATION SYSTEM FOR NYLON INJECTION AND EXTRUSION MATERIALS (PA) from SAI Global. ASTM D Standard Classification System for Nylon Injection and Extrusion Materials (PA). standard by ASTM International, 07/01/ View all product. 暂无评价|0人阅读|0次下载 | 举报文档. D – 01A Nylon Injection and Extrusion Materials_能源/化工_工程科技_专业资料。ASTM D标准.

Author: Yozshutaur Kazitaur
Country: Ghana
Language: English (Spanish)
Genre: Automotive
Published (Last): 14 March 2011
Pages: 125
PDF File Size: 3.64 Mb
ePub File Size: 19.37 Mb
ISBN: 743-9-44500-720-6
Downloads: 15965
Price: Free* [*Free Regsitration Required]
Uploader: Meztidal

The test specimen is a disk NOTE 7—An example of this classi? D — Historical Version s – view previous versions of standard. It is possible that materials incorporating other pigments or soluble stabilizers, or both may prove adequate for particular applications. There may be other requirements necessary to identify particular characteristics important to specialized applications.

F Flexural modulus shall be determined on Test Method D test specimens awtm.

D Terminology Relating to Plastics. No asfm shall be intentionally added to reach this level. Recommended processing temperatures are shown in Table 3. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

This table will be used in a manner similar to Table A. This section may also include descriptions of the changes or reasons for the changes, or both.

  68402 EATON PDF

Industrial & Engineering Plastics

This standard does not purport to address all of the safety concerns, if any, associated with its use. Inspection frequency shall be adequate to ensure the material is certi? Refer to Table X3. These will be spelled out in detail and identi? The x4066 point, Tm, is obtained from the second melting curve. Active view current version of standard. Viscosities for Groups 03, 04, 06, and 08 are measured as 4d066 as follows.

The following pieces are to be used for the listed relevant test methods: This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?

A specific hazards statement is given in The test specimen shall be a disk These shall be agreed upon between the user and the supplier, by using the suffixes as given in Section 5. E Tensile strength and elongation shall be determined on Test Method D test specimens 3. NOTE 11—Pigmented or colored nylons can differ signi?

Conformance or nonconformance is based on this comparison. To be agreed upon between the user and the supplier.

Military and Federal Specifications and Standards: D If a speci? D — 01a Standard Classi? Selection of process temperature is made based on the major polymer component. No descriptions are listed unless needed to describe a special grade under the class.

  MAMI TATI MA AUZITI PDF

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.

There may be other requirements necessary to identify particular characteristics important to specialized applications. Five specimens shall be tested.

ASTM D – 13 Standard Classification System for Nylon Injection and Extrusion Materials (PA)

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. This standard does not purport to address all of the safety concerns, if any, associated with its use.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations d44066 to use. Maximum moisture content of specimens shall be 0. These may be speci?